~ [ source navigation ] ~ [ diff markup ] ~ [ identifier search ] ~

TOMOYO Linux Cross Reference
Linux/Documentation/devicetree/bindings/net/marvell-bt-8xxx.txt

Version: ~ [ linux-6.12-rc7 ] ~ [ linux-6.11.7 ] ~ [ linux-6.10.14 ] ~ [ linux-6.9.12 ] ~ [ linux-6.8.12 ] ~ [ linux-6.7.12 ] ~ [ linux-6.6.60 ] ~ [ linux-6.5.13 ] ~ [ linux-6.4.16 ] ~ [ linux-6.3.13 ] ~ [ linux-6.2.16 ] ~ [ linux-6.1.116 ] ~ [ linux-6.0.19 ] ~ [ linux-5.19.17 ] ~ [ linux-5.18.19 ] ~ [ linux-5.17.15 ] ~ [ linux-5.16.20 ] ~ [ linux-5.15.171 ] ~ [ linux-5.14.21 ] ~ [ linux-5.13.19 ] ~ [ linux-5.12.19 ] ~ [ linux-5.11.22 ] ~ [ linux-5.10.229 ] ~ [ linux-5.9.16 ] ~ [ linux-5.8.18 ] ~ [ linux-5.7.19 ] ~ [ linux-5.6.19 ] ~ [ linux-5.5.19 ] ~ [ linux-5.4.285 ] ~ [ linux-5.3.18 ] ~ [ linux-5.2.21 ] ~ [ linux-5.1.21 ] ~ [ linux-5.0.21 ] ~ [ linux-4.20.17 ] ~ [ linux-4.19.323 ] ~ [ linux-4.18.20 ] ~ [ linux-4.17.19 ] ~ [ linux-4.16.18 ] ~ [ linux-4.15.18 ] ~ [ linux-4.14.336 ] ~ [ linux-4.13.16 ] ~ [ linux-4.12.14 ] ~ [ linux-4.11.12 ] ~ [ linux-4.10.17 ] ~ [ linux-4.9.337 ] ~ [ linux-4.4.302 ] ~ [ linux-3.10.108 ] ~ [ linux-2.6.32.71 ] ~ [ linux-2.6.0 ] ~ [ linux-2.4.37.11 ] ~ [ unix-v6-master ] ~ [ ccs-tools-1.8.12 ] ~ [ policy-sample ] ~
Architecture: ~ [ i386 ] ~ [ alpha ] ~ [ m68k ] ~ [ mips ] ~ [ ppc ] ~ [ sparc ] ~ [ sparc64 ] ~

Diff markup

Differences between /Documentation/devicetree/bindings/net/marvell-bt-8xxx.txt (Version linux-6.12-rc7) and /Documentation/devicetree/bindings/net/marvell-bt-8xxx.txt (Version policy-sample)


  1 Marvell 8897/8997 (sd8897/sd8997) bluetooth de    
  2 ------                                            
  3 The 8997 devices supports multiple interfaces.    
  4 the btmrvl driver is used and when used on USB    
  5 used.                                             
  6                                                   
  7 Required properties:                              
  8                                                   
  9   - compatible : should be one of the followin    
 10         * "marvell,sd8897-bt" (for SDIO)          
 11         * "marvell,sd8997-bt" (for SDIO)          
 12         * "usb1286,204e"      (for USB)           
 13                                                   
 14 Optional properties:                              
 15                                                   
 16   - marvell,cal-data: Calibration data downloa    
 17                       initialization. This is     
 18                       This is only applicable     
 19                                                   
 20   - marvell,wakeup-pin: It represents wakeup p    
 21                         firmware will use the     
 22   - marvell,wakeup-gap-ms: wakeup gap represen    
 23                       platform. The value will    
 24                       is needed to work chip's    
 25   - interrupt-names: Used only for USB based d    
 26   - interrupts : specifies the interrupt pin n    
 27                  driver will use the first int    
 28                  array. For USB based devices,    
 29                  named "wakeup" from the inter    
 30                  The driver will request an ir    
 31                  During system suspend, the ir    
 32                  bluetooth chip can wakeup hos    
 33                  conditions. During system res    
 34                  to make sure unnecessary inte    
 35                                                   
 36 Example:                                          
 37                                                   
 38 IRQ pin 119 is used as system wakeup source in    
 39 wakeup pin 13 and gap 100ms are configured so     
 40 using this device side pin and wakeup latency.    
 41                                                   
 42 Example for SDIO device follows (calibration d    
 43 below example).                                   
 44                                                   
 45 &mmc3 {                                           
 46         vmmc-supply = <&wlan_en_reg>;             
 47         bus-width = <4>;                          
 48         cap-power-off-card;                       
 49         keep-power-in-suspend;                    
 50                                                   
 51         #address-cells = <1>;                     
 52         #size-cells = <0>;                        
 53         btmrvl: bluetooth@2 {                     
 54                 compatible = "marvell,sd8897-b    
 55                 reg = <2>;                        
 56                 interrupt-parent = <&pio>;        
 57                 interrupts = <119 IRQ_TYPE_LEV    
 58                                                   
 59                 marvell,cal-data = /bits/ 8 <     
 60                         0x37 0x01 0x1c 0x00 0x    
 61                         0x00 0x00 0xba 0xce 0x    
 62                         0x00 0x00 0xf0 0x00>;     
 63                 marvell,wakeup-pin = /bits/ 16    
 64                 marvell,wakeup-gap-ms = /bits/    
 65         };                                        
 66 };                                                
 67                                                   
 68 Example for USB device:                           
 69                                                   
 70 &usb_host1_ohci {                                 
 71     #address-cells = <1>;                         
 72     #size-cells = <0>;                            
 73                                                   
 74     mvl_bt1: bt@1 {                               
 75         compatible = "usb1286,204e";              
 76         reg = <1>;                                
 77         interrupt-parent = <&gpio0>;              
 78         interrupt-names = "wakeup";               
 79         interrupts = <119 IRQ_TYPE_LEVEL_LOW>;    
 80         marvell,wakeup-pin = /bits/ 16 <0x0d>;    
 81         marvell,wakeup-gap-ms = /bits/ 16 <0x6    
 82     };                                            
 83 };                                                
                                                      

~ [ source navigation ] ~ [ diff markup ] ~ [ identifier search ] ~

kernel.org | git.kernel.org | LWN.net | Project Home | SVN repository | Mail admin

Linux® is a registered trademark of Linus Torvalds in the United States and other countries.
TOMOYO® is a registered trademark of NTT DATA CORPORATION.

sflogo.php