1 // SPDX-License-Identifier: GPL-2.0
2 /*
3 * at91-wb50n.dtsi - Device Tree include file
4 *
5 * Copyright (C) 2018 Laird
6 *
7 */
8
9 #include "sama5d31.dtsi"
10
11 / {
12 model = "Laird Workgroup Bridge 50N -
13 compatible = "laird,wb50n", "atmel,sam
14
15 chosen {
16 bootargs = "ubi.mtd=6 root=ubi
17 stdout-path = "serial0:115200n
18 };
19
20 memory@20000000 {
21 reg = <0x20000000 0x4000000>;
22 };
23 };
24
25 &pinctrl {
26 board {
27 pinctrl_mmc0_cd: mmc0_cd {
28 atmel,pins = <AT91_PIO
29 };
30
31 pinctrl_usba_vbus: usba_vbus {
32 atmel,pins = <AT91_PIO
33 };
34 };
35 };
36
37 &slow_xtal {
38 clock-frequency = <32768>;
39 };
40
41 &main_xtal {
42 clock-frequency = <12000000>;
43 };
44
45 &clk32k {
46 atmel,osc-bypass;
47 };
48
49 &mmc0 {
50 pinctrl-names = "default";
51 pinctrl-0 = <&pinctrl_mmc0_clk_cmd_dat
52 cd-gpios = <&pioC 26 GPIO_ACTIVE_LOW>;
53 slot@0 {
54 reg = <0>;
55 bus-width = <4>;
56 };
57 };
58
59 &mmc1 {
60 pinctrl-names = "default";
61 pinctrl-0 = <&pinctrl_mmc1_clk_cmd_dat
62 status = "okay";
63 atheros@0 {
64 compatible = "atheros,ath6kl";
65 atheros,board-id = "SD32";
66 reg = <0>;
67 bus-width = <4>;
68 };
69 };
70
71 &macb1 {
72 phy-mode = "rmii";
73 };
74
75 &dbgu {
76 dmas = <0>, <0>; /* Do not use
77 };
78
79 /* On BB40 this port is labeled UART1 */
80 &usart0 {
81 atmel,use-dma-rx;
82 atmel,use-dma-tx;
83 pinctrl-names = "default";
84 pinctrl-0 = <&pinctrl_usart0 &pinctrl_
85 };
86
87 /* On BB40 this port is labeled UART0 */
88 &usart1 {
89 atmel,use-dma-rx;
90 atmel,use-dma-tx;
91 pinctrl-names = "default";
92 pinctrl-0 = <&pinctrl_usart1 &pinctrl_
93 dtr-gpios = <&pioD 13 GPIO_ACTIVE_LOW>
94 dsr-gpios = <&pioD 11 GPIO_ACTIVE_LOW>
95 dcd-gpios = <&pioD 7 GPIO_ACTIVE_LOW>;
96 rng-gpios = <&pioD 8 GPIO_ACTIVE_LOW>;
97 };
98
99 /* USART3 is direct-connect to the Bluetooth U
100 &usart3 {
101 atmel,use-dma-rx;
102 atmel,use-dma-tx;
103 pinctrl-names = "default";
104 pinctrl-0 = <&pinctrl_usart3 &pinctrl_
105 status = "okay";
106 };
107
108 &spi1 {
109 cs-gpios = <&pioC 25 0>, <0>, <0>, <0>
110 };
111
112 &ebi {
113 pinctrl-0 = <&pinctrl_ebi_nand_addr>;
114 pinctrl-names = "default";
115 status = "okay";
116 };
117
118 &nand_controller {
119 status = "okay";
120
121 nand: nand@3 {
122 reg = <0x3 0x0 0x2>;
123 atmel,rb = <0>;
124 nand-bus-width = <8>;
125 nand-ecc-mode = "hw";
126 nand-ecc-strength = <8>;
127 nand-ecc-step-size = <512>;
128 nand-on-flash-bbt;
129 label = "atmel_nand";
130
131 partitions {
132 compatible = "fixed-pa
133 #address-cells = <1>;
134 #size-cells = <1>;
135
136 at91bootstrap@0 {
137 label = "at91b
138 reg = <0x0 0x2
139 };
140
141 uboot@20000 {
142 label = "u-boo
143 reg = <0x20000
144 };
145
146 ubootenv@a0000 {
147 label = "u-boo
148 reg = <0xa0000
149 };
150
151 ubootenv@c0000 {
152 label = "u-boo
153 reg = <0xc0000
154 };
155
156 kernel-a@e0000 {
157 label = "kerne
158 reg = <0xe0000
159 };
160
161 kernel-b@5e0000 {
162 label = "kerne
163 reg = <0x5e000
164 };
165
166 rootfs-a@ae0000 {
167 label = "rootf
168 reg = <0xae000
169 };
170
171 rootfs-b@3ae0000 {
172 label = "rootf
173 reg = <0x3ae00
174 };
175
176 user@6ae0000 {
177 label = "user"
178 reg = <0x6ae00
179 };
180 };
181 };
182 };
183
184 &usb0 {
185 atmel,vbus-gpio = <&pioB 13 GPIO_ACTIV
186 pinctrl-names = "default";
187 pinctrl-0 = <&pinctrl_usba_vbus>;
188 };
189
190 &usb1 {
191 num-ports = <3>;
192 atmel,vbus-gpio = <&pioA 2 GPIO_ACTIVE
193 atmel,oc-gpio = <&pioA 4 GPIO_ACTIVE_L
194 };
Linux® is a registered trademark of Linus Torvalds in the United States and other countries.
TOMOYO® is a registered trademark of NTT DATA CORPORATION.