1 ST USB EHCI controller
2
3 Required properties:
4 - compatible : must be "st,st-ehci-300x"
5 - reg : physical base addresses of the controller and length of memory mapped
6 region
7 - interrupts : one EHCI interrupt should be described here
8 - pinctrl-names : a pinctrl state named "default" must be defined
9 - pinctrl-0 : phandle referencing pin configuration of the USB controller
10 See: Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
11 - clocks : phandle list of usb clocks
12 - clock-names : should be "ic" for interconnect clock and "clk48"
13 See: Documentation/devicetree/bindings/clock/clock-bindings.txt
14
15 - phys : phandle for the PHY device
16 - phy-names : should be "usb"
17 - resets : phandle + reset specifier pairs to the powerdown and softreset lines
18 of the USB IP
19 - reset-names : should be "power" and "softreset"
20 See: Documentation/devicetree/bindings/reset/st,stih407-powerdown.yaml
21 See: Documentation/devicetree/bindings/reset/reset.txt
22
23 Example:
24
25 ehci1: usb@fe203e00 {
26 compatible = "st,st-ehci-300x";
27 reg = <0xfe203e00 0x100>;
28 interrupts = <GIC_SPI 148 IRQ_TYPE_NONE>;
29 pinctrl-names = "default";
30 pinctrl-0 = <&pinctrl_usb1>;
31 clocks = <&clk_s_a1_ls 0>;
32 phys = <&usb2_phy>;
33 phy-names = "usb";
34
35 resets = <&powerdown STIH416_USB1_POWERDOWN>,
36 <&softreset STIH416_USB1_SOFTRESET>;
37 reset-names = "power", "softreset";
38 };
Linux® is a registered trademark of Linus Torvalds in the United States and other countries.
TOMOYO® is a registered trademark of NTT DATA CORPORATION.