1 ================== 2 Partial Parity Log 3 ================== 4 5 Partial Parity Log (PPL) is a feature available for RAID5 arrays. The issue 6 addressed by PPL is that after a dirty shutdown, parity of a particular stripe 7 may become inconsistent with data on other member disks. If the array is also 8 in degraded state, there is no way to recalculate parity, because one of the 9 disks is missing. This can lead to silent data corruption when rebuilding the 10 array or using it is as degraded - data calculated from parity for array blocks 11 that have not been touched by a write request during the unclean shutdown can 12 be incorrect. Such condition is known as the RAID5 Write Hole. Because of 13 this, md by default does not allow starting a dirty degraded array. 14 15 Partial parity for a write operation is the XOR of stripe data chunks not 16 modified by this write. It is just enough data needed for recovering from the 17 write hole. XORing partial parity with the modified chunks produces parity for 18 the stripe, consistent with its state before the write operation, regardless of 19 which chunk writes have completed. If one of the not modified data disks of 20 this stripe is missing, this updated parity can be used to recover its 21 contents. PPL recovery is also performed when starting an array after an 22 unclean shutdown and all disks are available, eliminating the need to resync 23 the array. Because of this, using write-intent bitmap and PPL together is not 24 supported. 25 26 When handling a write request PPL writes partial parity before new data and 27 parity are dispatched to disks. PPL is a distributed log - it is stored on 28 array member drives in the metadata area, on the parity drive of a particular 29 stripe. It does not require a dedicated journaling drive. Write performance is 30 reduced by up to 30%-40% but it scales with the number of drives in the array 31 and the journaling drive does not become a bottleneck or a single point of 32 failure. 33 34 Unlike raid5-cache, the other solution in md for closing the write hole, PPL is 35 not a true journal. It does not protect from losing in-flight data, only from 36 silent data corruption. If a dirty disk of a stripe is lost, no PPL recovery is 37 performed for this stripe (parity is not updated). So it is possible to have 38 arbitrary data in the written part of a stripe if that disk is lost. In such 39 case the behavior is the same as in plain raid5. 40 41 PPL is available for md version-1 metadata and external (specifically IMSM) 42 metadata arrays. It can be enabled using mdadm option --consistency-policy=ppl. 43 44 There is a limitation of maximum 64 disks in the array for PPL. It allows to 45 keep data structures and implementation simple. RAID5 arrays with so many disks 46 are not likely due to high risk of multiple disks failure. Such restriction 47 should not be a real life limitation.
Linux® is a registered trademark of Linus Torvalds in the United States and other countries.
TOMOYO® is a registered trademark of NTT DATA CORPORATION.