1 /* SPDX-License-Identifier: GPL-2.0 */ 2 #ifndef LINUX_BCMA_REGS_H_ 3 #define LINUX_BCMA_REGS_H_ 4 5 /* Some single registers are shared between many cores */ 6 /* BCMA_CLKCTLST: ChipCommon (rev >= 20), PCIe, 80211 */ 7 #define BCMA_CLKCTLST 0x01E0 /* Clock control and status */ 8 #define BCMA_CLKCTLST_FORCEALP 0x00000001 /* Force ALP request */ 9 #define BCMA_CLKCTLST_FORCEHT 0x00000002 /* Force HT request */ 10 #define BCMA_CLKCTLST_FORCEILP 0x00000004 /* Force ILP request */ 11 #define BCMA_CLKCTLST_HAVEALPREQ 0x00000008 /* ALP available request */ 12 #define BCMA_CLKCTLST_HAVEHTREQ 0x00000010 /* HT available request */ 13 #define BCMA_CLKCTLST_HWCROFF 0x00000020 /* Force HW clock request off */ 14 #define BCMA_CLKCTLST_HQCLKREQ 0x00000040 /* HQ Clock */ 15 #define BCMA_CLKCTLST_EXTRESREQ 0x00000700 /* Mask of external resource requests */ 16 #define BCMA_CLKCTLST_EXTRESREQ_SHIFT 8 17 #define BCMA_CLKCTLST_HAVEALP 0x00010000 /* ALP available */ 18 #define BCMA_CLKCTLST_HAVEHT 0x00020000 /* HT available */ 19 #define BCMA_CLKCTLST_BP_ON_ALP 0x00040000 /* RO: running on ALP clock */ 20 #define BCMA_CLKCTLST_BP_ON_HT 0x00080000 /* RO: running on HT clock */ 21 #define BCMA_CLKCTLST_EXTRESST 0x07000000 /* Mask of external resource status */ 22 #define BCMA_CLKCTLST_EXTRESST_SHIFT 24 23 /* Is there any BCM4328 on BCMA bus? */ 24 #define BCMA_CLKCTLST_4328A0_HAVEHT 0x00010000 /* 4328a0 has reversed bits */ 25 #define BCMA_CLKCTLST_4328A0_HAVEALP 0x00020000 /* 4328a0 has reversed bits */ 26 27 /* Agent registers (common for every core) */ 28 #define BCMA_OOB_SEL_OUT_A30 0x0100 29 #define BCMA_IOCTL 0x0408 /* IO control */ 30 #define BCMA_IOCTL_CLK 0x0001 31 #define BCMA_IOCTL_FGC 0x0002 32 #define BCMA_IOCTL_CORE_BITS 0x3FFC 33 #define BCMA_IOCTL_PME_EN 0x4000 34 #define BCMA_IOCTL_BIST_EN 0x8000 35 #define BCMA_IOST 0x0500 /* IO status */ 36 #define BCMA_IOST_CORE_BITS 0x0FFF 37 #define BCMA_IOST_DMA64 0x1000 38 #define BCMA_IOST_GATED_CLK 0x2000 39 #define BCMA_IOST_BIST_ERROR 0x4000 40 #define BCMA_IOST_BIST_DONE 0x8000 41 #define BCMA_RESET_CTL 0x0800 42 #define BCMA_RESET_CTL_RESET 0x0001 43 #define BCMA_RESET_ST 0x0804 44 45 #define BCMA_NS_ROM_IOST_BOOT_DEV_MASK 0x0003 46 #define BCMA_NS_ROM_IOST_BOOT_DEV_NOR 0x0000 47 #define BCMA_NS_ROM_IOST_BOOT_DEV_NAND 0x0001 48 #define BCMA_NS_ROM_IOST_BOOT_DEV_ROM 0x0002 49 50 /* BCMA PCI config space registers. */ 51 #define BCMA_PCI_PMCSR 0x44 52 #define BCMA_PCI_PE 0x100 53 #define BCMA_PCI_BAR0_WIN 0x80 /* Backplane address space 0 */ 54 #define BCMA_PCI_BAR1_WIN 0x84 /* Backplane address space 1 */ 55 #define BCMA_PCI_SPROMCTL 0x88 /* SPROM control */ 56 #define BCMA_PCI_SPROMCTL_WE 0x10 /* SPROM write enable */ 57 #define BCMA_PCI_BAR1_CONTROL 0x8c /* Address space 1 burst control */ 58 #define BCMA_PCI_IRQS 0x90 /* PCI interrupts */ 59 #define BCMA_PCI_IRQMASK 0x94 /* PCI IRQ control and mask (pcirev >= 6 only) */ 60 #define BCMA_PCI_BACKPLANE_IRQS 0x98 /* Backplane Interrupts */ 61 #define BCMA_PCI_BAR0_WIN2 0xAC 62 #define BCMA_PCI_GPIO_IN 0xB0 /* GPIO Input (pcirev >= 3 only) */ 63 #define BCMA_PCI_GPIO_OUT 0xB4 /* GPIO Output (pcirev >= 3 only) */ 64 #define BCMA_PCI_GPIO_OUT_ENABLE 0xB8 /* GPIO Output Enable/Disable (pcirev >= 3 only) */ 65 #define BCMA_PCI_GPIO_SCS 0x10 /* PCI config space bit 4 for 4306c0 slow clock source */ 66 #define BCMA_PCI_GPIO_HWRAD 0x20 /* PCI config space GPIO 13 for hw radio disable */ 67 #define BCMA_PCI_GPIO_XTAL 0x40 /* PCI config space GPIO 14 for Xtal powerup */ 68 #define BCMA_PCI_GPIO_PLL 0x80 /* PCI config space GPIO 15 for PLL powerdown */ 69 70 #define BCMA_PCIE2_BAR0_WIN2 0x70 71 72 /* SiliconBackplane Address Map. 73 * All regions may not exist on all chips. 74 */ 75 #define BCMA_SOC_SDRAM_BASE 0x00000000U /* Physical SDRAM */ 76 #define BCMA_SOC_PCI_MEM 0x08000000U /* Host Mode sb2pcitranslation0 (64 MB) */ 77 #define BCMA_SOC_PCI_MEM_SZ (64 * 1024 * 1024) 78 #define BCMA_SOC_PCI_CFG 0x0c000000U /* Host Mode sb2pcitranslation1 (64 MB) */ 79 #define BCMA_SOC_SDRAM_SWAPPED 0x10000000U /* Byteswapped Physical SDRAM */ 80 #define BCMA_SOC_SDRAM_R2 0x80000000U /* Region 2 for sdram (512 MB) */ 81 82 83 #define BCMA_SOC_PCI_DMA 0x40000000U /* Client Mode sb2pcitranslation2 (1 GB) */ 84 #define BCMA_SOC_PCI_DMA2 0x80000000U /* Client Mode sb2pcitranslation2 (1 GB) */ 85 #define BCMA_SOC_PCI_DMA_SZ 0x40000000U /* Client Mode sb2pcitranslation2 size in bytes */ 86 #define BCMA_SOC_PCIE_DMA_L32 0x00000000U /* PCIE Client Mode sb2pcitranslation2 87 * (2 ZettaBytes), low 32 bits 88 */ 89 #define BCMA_SOC_PCIE_DMA_H32 0x80000000U /* PCIE Client Mode sb2pcitranslation2 90 * (2 ZettaBytes), high 32 bits 91 */ 92 93 #define BCMA_SOC_PCI1_MEM 0x40000000U /* Host Mode sb2pcitranslation0 (64 MB) */ 94 #define BCMA_SOC_PCI1_CFG 0x44000000U /* Host Mode sb2pcitranslation1 (64 MB) */ 95 #define BCMA_SOC_PCIE1_DMA_H32 0xc0000000U /* PCIE Client Mode sb2pcitranslation2 96 * (2 ZettaBytes), high 32 bits 97 */ 98 99 #define BCMA_SOC_FLASH1 0x1fc00000 /* MIPS Flash Region 1 */ 100 #define BCMA_SOC_FLASH1_SZ 0x00400000 /* MIPS Size of Flash Region 1 */ 101 #define BCMA_SOC_FLASH2 0x1c000000 /* Flash Region 2 (region 1 shadowed here) */ 102 #define BCMA_SOC_FLASH2_SZ 0x02000000 /* Size of Flash Region 2 */ 103 104 #endif /* LINUX_BCMA_REGS_H_ */ 105
Linux® is a registered trademark of Linus Torvalds in the United States and other countries.
TOMOYO® is a registered trademark of NTT DATA CORPORATION.