~ [ source navigation ] ~ [ diff markup ] ~ [ identifier search ] ~

TOMOYO Linux Cross Reference
Linux/include/scsi/fc/fc_fcp.h

Version: ~ [ linux-6.11-rc3 ] ~ [ linux-6.10.4 ] ~ [ linux-6.9.12 ] ~ [ linux-6.8.12 ] ~ [ linux-6.7.12 ] ~ [ linux-6.6.45 ] ~ [ linux-6.5.13 ] ~ [ linux-6.4.16 ] ~ [ linux-6.3.13 ] ~ [ linux-6.2.16 ] ~ [ linux-6.1.104 ] ~ [ linux-6.0.19 ] ~ [ linux-5.19.17 ] ~ [ linux-5.18.19 ] ~ [ linux-5.17.15 ] ~ [ linux-5.16.20 ] ~ [ linux-5.15.164 ] ~ [ linux-5.14.21 ] ~ [ linux-5.13.19 ] ~ [ linux-5.12.19 ] ~ [ linux-5.11.22 ] ~ [ linux-5.10.223 ] ~ [ linux-5.9.16 ] ~ [ linux-5.8.18 ] ~ [ linux-5.7.19 ] ~ [ linux-5.6.19 ] ~ [ linux-5.5.19 ] ~ [ linux-5.4.281 ] ~ [ linux-5.3.18 ] ~ [ linux-5.2.21 ] ~ [ linux-5.1.21 ] ~ [ linux-5.0.21 ] ~ [ linux-4.20.17 ] ~ [ linux-4.19.319 ] ~ [ linux-4.18.20 ] ~ [ linux-4.17.19 ] ~ [ linux-4.16.18 ] ~ [ linux-4.15.18 ] ~ [ linux-4.14.336 ] ~ [ linux-4.13.16 ] ~ [ linux-4.12.14 ] ~ [ linux-4.11.12 ] ~ [ linux-4.10.17 ] ~ [ linux-4.9.337 ] ~ [ linux-4.4.302 ] ~ [ linux-3.10.108 ] ~ [ linux-2.6.32.71 ] ~ [ linux-2.6.0 ] ~ [ linux-2.4.37.11 ] ~ [ unix-v6-master ] ~ [ ccs-tools-1.8.9 ] ~ [ policy-sample ] ~
Architecture: ~ [ i386 ] ~ [ alpha ] ~ [ m68k ] ~ [ mips ] ~ [ ppc ] ~ [ sparc ] ~ [ sparc64 ] ~

  1 /* SPDX-License-Identifier: GPL-2.0-only */
  2 /*
  3  * Copyright(c) 2007 Intel Corporation. All rights reserved.
  4  *
  5  * Maintained at www.Open-FCoE.org
  6  */
  7 
  8 #ifndef _FC_FCP_H_
  9 #define _FC_FCP_H_
 10 
 11 #include <scsi/scsi.h>
 12 
 13 /*
 14  * Fibre Channel Protocol for SCSI.
 15  * From T10 FCP-3, T10 project 1560-D Rev 4, Sept. 13, 2005.
 16  */
 17 
 18 /*
 19  * fc/fs.h defines FC_TYPE_FCP.
 20  */
 21 
 22 /*
 23  * Service parameter page parameters (word 3 bits) for Process Login.
 24  */
 25 #define FCP_SPPF_TASK_RETRY_ID  0x0200  /* task retry ID requested */
 26 #define FCP_SPPF_RETRY          0x0100  /* retry supported */
 27 #define FCP_SPPF_CONF_COMPL     0x0080  /* confirmed completion allowed */
 28 #define FCP_SPPF_OVLY_ALLOW     0x0040  /* data overlay allowed */
 29 #define FCP_SPPF_INIT_FCN       0x0020  /* initiator function */
 30 #define FCP_SPPF_TARG_FCN       0x0010  /* target function */
 31 #define FCP_SPPF_RD_XRDY_DIS    0x0002  /* disable XFER_RDY for reads */
 32 #define FCP_SPPF_WR_XRDY_DIS    0x0001  /* disable XFER_RDY for writes */
 33 
 34 /*
 35  * FCP_CMND IU Payload.
 36  */
 37 struct fcp_cmnd {
 38         struct scsi_lun fc_lun;         /* logical unit number */
 39         __u8            fc_cmdref;      /* command reference number */
 40         __u8            fc_pri_ta;      /* priority and task attribute */
 41         __u8            fc_tm_flags;    /* task management flags */
 42         __u8            fc_flags;       /* additional len & flags */
 43         __u8            fc_cdb[16];     /* base CDB */
 44         __be32          fc_dl;          /* data length (must follow fc_cdb) */
 45 };
 46 
 47 #define FCP_CMND_LEN    32      /* expected length of structure */
 48 
 49 struct fcp_cmnd32 {
 50         struct scsi_lun fc_lun;         /* logical unit number */
 51         __u8            fc_cmdref;      /* command reference number */
 52         __u8            fc_pri_ta;      /* priority and task attribute */
 53         __u8            fc_tm_flags;    /* task management flags */
 54         __u8            fc_flags;       /* additional len & flags */
 55         __u8            fc_cdb[32];     /* base CDB */
 56         __be32          fc_dl;          /* data length (must follow fc_cdb) */
 57 };
 58 
 59 #define FCP_CMND32_LEN      48  /* expected length of structure */
 60 #define FCP_CMND32_ADD_LEN  (16 / 4)    /* Additional cdb length */
 61 
 62 /*
 63  * fc_pri_ta.
 64  */
 65 #define FCP_PTA_SIMPLE      0   /* simple task attribute */
 66 #define FCP_PTA_HEADQ       1   /* head of queue task attribute */
 67 #define FCP_PTA_ORDERED     2   /* ordered task attribute */
 68 #define FCP_PTA_ACA         4   /* auto. contingent allegiance */
 69 #define FCP_PTA_MASK        7   /* mask for task attribute field */
 70 #define FCP_PRI_SHIFT       3   /* priority field starts in bit 3 */
 71 #define FCP_PRI_RESVD_MASK  0x80        /* reserved bits in priority field */
 72 
 73 /*
 74  * fc_tm_flags - task management flags field.
 75  */
 76 #define FCP_TMF_CLR_ACA         0x40    /* clear ACA condition */
 77 #define FCP_TMF_TGT_RESET       0x20    /* target reset task management,
 78                                            deprecated as of FCP-3 */
 79 #define FCP_TMF_LUN_RESET       0x10    /* logical unit reset task management */
 80 #define FCP_TMF_CLR_TASK_SET    0x04    /* clear task set */
 81 #define FCP_TMF_ABT_TASK_SET    0x02    /* abort task set */
 82 
 83 /*
 84  * fc_flags.
 85  *  Bits 7:2 are the additional FCP_CDB length / 4.
 86  */
 87 #define FCP_CFL_LEN_MASK        0xfc    /* mask for additional length */
 88 #define FCP_CFL_LEN_SHIFT       2       /* shift bits for additional length */
 89 #define FCP_CFL_RDDATA          0x02    /* read data */
 90 #define FCP_CFL_WRDATA          0x01    /* write data */
 91 
 92 /*
 93  * FCP_TXRDY IU - transfer ready payload.
 94  */
 95 struct fcp_txrdy {
 96         __be32          ft_data_ro;     /* data relative offset */
 97         __be32          ft_burst_len;   /* burst length */
 98         __u8            _ft_resvd[4];   /* reserved */
 99 };
100 
101 #define FCP_TXRDY_LEN   12      /* expected length of structure */
102 
103 /*
104  * FCP_RESP IU - response payload.
105  *
106  * The response payload comes in three parts: the flags/status, the
107  * sense/response lengths and the sense data/response info section.
108  *
109  * From FCP3r04, note 6 of section 9.5.13:
110  *
111  * Some early implementations presented the FCP_RSP IU without the FCP_RESID,
112  * FCP_SNS_LEN, and FCP_RSP_LEN fields if the FCP_RESID_UNDER, FCP_RESID_OVER,
113  * FCP_SNS_LEN_VALID, and FCP_RSP_LEN_VALID bits were all set to zero. This
114  * non-standard behavior should be tolerated.
115  *
116  * All response frames will always contain the fcp_resp template.  Some
117  * will also include the fcp_resp_len template.
118  *
119  * From Table 23, the FCP_RSP_INFO can either be 4 bytes or 8 bytes, both
120  * are valid length.
121  */
122 struct fcp_resp {
123         __u8            _fr_resvd[8];   /* reserved */
124         __be16          fr_retry_delay; /* retry delay timer */
125         __u8            fr_flags;       /* flags */
126         __u8            fr_status;      /* SCSI status code */
127 };
128 
129 #define FCP_RESP_LEN    12      /* expected length of structure */
130 
131 struct fcp_resp_ext {
132         __be32          fr_resid;       /* Residual value */
133         __be32          fr_sns_len;     /* SCSI Sense length */
134         __be32          fr_rsp_len;     /* Response Info length */
135 
136         /*
137          * Optionally followed by RSP info and/or SNS info and/or
138          * bidirectional read residual length, if any.
139          */
140 };
141 
142 #define FCP_RESP_EXT_LEN    12  /* expected length of the structure */
143 
144 struct fcp_resp_rsp_info {
145     __u8      _fr_resvd[3];       /* reserved */
146     __u8      rsp_code;           /* Response Info Code */
147     __u8      _fr_resvd2[4];      /* reserved */
148 };
149 
150 #define FCP_RESP_RSP_INFO_LEN4    4 /* without reserved field */
151 #define FCP_RESP_RSP_INFO_LEN8    8 /* with reserved field */
152 
153 struct fcp_resp_with_ext {
154         struct fcp_resp resp;
155         struct fcp_resp_ext ext;
156 };
157 
158 #define FCP_RESP_WITH_EXT   (FCP_RESP_LEN + FCP_RESP_EXT_LEN)
159 
160 /*
161  * fr_flags.
162  */
163 #define FCP_BIDI_RSP        0x80        /* bidirectional read response */
164 #define FCP_BIDI_READ_UNDER 0x40        /* bidir. read less than requested */
165 #define FCP_BIDI_READ_OVER  0x20        /* DL insufficient for full transfer */
166 #define FCP_CONF_REQ        0x10        /* confirmation requested */
167 #define FCP_RESID_UNDER     0x08        /* transfer shorter than expected */
168 #define FCP_RESID_OVER      0x04        /* DL insufficient for full transfer */
169 #define FCP_SNS_LEN_VAL     0x02        /* SNS_LEN field is valid */
170 #define FCP_RSP_LEN_VAL     0x01        /* RSP_LEN field is valid */
171 
172 /*
173  * rsp_codes
174  */
175 enum fcp_resp_rsp_codes {
176         FCP_TMF_CMPL = 0,
177         FCP_DATA_LEN_INVALID = 1,
178         FCP_CMND_FIELDS_INVALID = 2,
179         FCP_DATA_PARAM_MISMATCH = 3,
180         FCP_TMF_REJECTED = 4,
181         FCP_TMF_FAILED = 5,
182         FCP_TMF_INVALID_LUN = 9,
183 };
184 
185 /*
186  * FCP SRR Link Service request - Sequence Retransmission Request.
187  */
188 struct fcp_srr {
189         __u8            srr_op;         /* opcode ELS_SRR */
190         __u8            srr_resvd[3];   /* opcode / reserved - must be zero */
191         __be16          srr_ox_id;      /* OX_ID of failed command */
192         __be16          srr_rx_id;      /* RX_ID of failed command */
193         __be32          srr_rel_off;    /* relative offset */
194         __u8            srr_r_ctl;      /* r_ctl for the information unit */
195         __u8            srr_resvd2[3];  /* reserved */
196 };
197 
198 /*
199  * Feature bits in name server FC-4 Features object.
200  */
201 #define FCP_FEAT_TARG   (1 << 0)        /* target function supported */
202 #define FCP_FEAT_INIT   (1 << 1)        /* initiator function supported */
203 
204 #endif /* _FC_FCP_H_ */
205 

~ [ source navigation ] ~ [ diff markup ] ~ [ identifier search ] ~

kernel.org | git.kernel.org | LWN.net | Project Home | SVN repository | Mail admin

Linux® is a registered trademark of Linus Torvalds in the United States and other countries.
TOMOYO® is a registered trademark of NTT DATA CORPORATION.

sflogo.php