1 // SPDX-License-Identifier: GPL-2.0
2 #include <dt-bindings/iio/qcom,spmi-vadc.h>
3 #include <dt-bindings/input/linux-event-codes.h>
4 #include <dt-bindings/interrupt-controller/irq.h>
5 #include <dt-bindings/spmi/spmi.h>
6
7 / {
8 thermal-zones {
9 pm8916-thermal {
10 polling-delay-passive = <100>;
11
12 thermal-sensors = <&pm8916_temp>;
13
14 trips {
15 trip0 {
16 temperature = <105000>;
17 hysteresis = <0>;
18 type = "passive";
19 };
20
21 trip1 {
22 temperature = <125000>;
23 hysteresis = <0>;
24 type = "hot";
25 };
26
27 trip2 {
28 temperature = <145000>;
29 hysteresis = <0>;
30 type = "critical";
31 };
32 };
33 };
34 };
35 };
36
37 &spmi_bus {
38 pm8916_0: pmic@0 {
39 compatible = "qcom,pm8916", "qcom,spmi-pmic";
40 reg = <0x0 SPMI_USID>;
41 #address-cells = <1>;
42 #size-cells = <0>;
43
44 pon@800 {
45 compatible = "qcom,pm8916-pon";
46 reg = <0x800>;
47 mode-bootloader = <0x2>;
48 mode-recovery = <0x1>;
49
50 pwrkey {
51 compatible = "qcom,pm8941-pwrkey";
52 interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
53 debounce = <15625>;
54 bias-pull-up;
55 linux,code = <KEY_POWER>;
56 };
57
58 pm8916_resin: resin {
59 compatible = "qcom,pm8941-resin";
60 interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
61 debounce = <15625>;
62 bias-pull-up;
63 status = "disabled";
64 };
65
66 watchdog {
67 compatible = "qcom,pm8916-wdt";
68 interrupts = <0x0 0x8 6 IRQ_TYPE_EDGE_RISING>;
69 timeout-sec = <60>;
70 };
71 };
72
73 pm8916_charger: charger@1000 {
74 compatible = "qcom,pm8916-lbc";
75 reg = <0x1000>, <0x1200>, <0x1300>, <0x1600>;
76 reg-names = "chgr", "bat_if", "usb", "misc";
77
78 interrupts = <0x0 0x10 0 IRQ_TYPE_EDGE_BOTH>,
79 <0x0 0x10 5 IRQ_TYPE_EDGE_BOTH>,
80 <0x0 0x10 6 IRQ_TYPE_EDGE_BOTH>,
81 <0x0 0x10 7 IRQ_TYPE_EDGE_BOTH>,
82 <0x0 0x12 0 IRQ_TYPE_EDGE_BOTH>,
83 <0x0 0x12 1 IRQ_TYPE_EDGE_BOTH>,
84 <0x0 0x13 0 IRQ_TYPE_EDGE_BOTH>,
85 <0x0 0x13 1 IRQ_TYPE_EDGE_BOTH>,
86 <0x0 0x13 2 IRQ_TYPE_EDGE_BOTH>,
87 <0x0 0x13 4 IRQ_TYPE_EDGE_BOTH>;
88 interrupt-names = "vbat_det",
89 "fast_chg",
90 "chg_fail",
91 "chg_done",
92 "bat_pres",
93 "temp_ok",
94 "coarse_det",
95 "usb_vbus",
96 "chg_gone",
97 "overtemp";
98
99 status = "disabled";
100 };
101
102 pm8916_usbin: usb-detect@1300 {
103 compatible = "qcom,pm8941-misc";
104 reg = <0x1300>;
105 interrupts = <0x0 0x13 1 IRQ_TYPE_EDGE_BOTH>;
106 interrupt-names = "usb_vbus";
107 status = "disabled";
108 };
109
110 pm8916_temp: temp-alarm@2400 {
111 compatible = "qcom,spmi-temp-alarm";
112 reg = <0x2400>;
113 interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>;
114 io-channels = <&pm8916_vadc VADC_DIE_TEMP>;
115 io-channel-names = "thermal";
116 #thermal-sensor-cells = <0>;
117 };
118
119 pm8916_vadc: adc@3100 {
120 compatible = "qcom,spmi-vadc";
121 reg = <0x3100>;
122 interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
123 #address-cells = <1>;
124 #size-cells = <0>;
125 #io-channel-cells = <1>;
126
127 channel@0 {
128 reg = <VADC_USBIN>;
129 qcom,pre-scaling = <1 10>;
130 };
131 channel@7 {
132 reg = <VADC_VSYS>;
133 qcom,pre-scaling = <1 3>;
134 };
135 channel@8 {
136 reg = <VADC_DIE_TEMP>;
137 };
138 channel@9 {
139 reg = <VADC_REF_625MV>;
140 };
141 channel@a {
142 reg = <VADC_REF_1250MV>;
143 };
144 channel@e {
145 reg = <VADC_GND_REF>;
146 };
147 channel@f {
148 reg = <VADC_VDD_VADC>;
149 };
150 };
151
152 pm8916_bms: battery@4000 {
153 compatible = "qcom,pm8916-bms-vm";
154 reg = <0x4000>;
155 interrupts = <0x0 0x40 0 IRQ_TYPE_EDGE_RISING>,
156 <0x0 0x40 1 IRQ_TYPE_EDGE_RISING>,
157 <0x0 0x40 2 IRQ_TYPE_EDGE_RISING>,
158 <0x0 0x40 3 IRQ_TYPE_EDGE_RISING>,
159 <0x0 0x40 4 IRQ_TYPE_EDGE_RISING>,
160 <0x0 0x40 5 IRQ_TYPE_EDGE_RISING>;
161 interrupt-names = "cv_leave",
162 "cv_enter",
163 "ocv_good",
164 "ocv_thr",
165 "fifo",
166 "state_chg";
167
168 status = "disabled";
169 };
170
171 rtc@6000 {
172 compatible = "qcom,pm8941-rtc";
173 reg = <0x6000>, <0x6100>;
174 reg-names = "rtc", "alarm";
175 interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
176 };
177
178 pm8916_mpps: mpps@a000 {
179 compatible = "qcom,pm8916-mpp", "qcom,spmi-mpp";
180 reg = <0xa000>;
181 gpio-controller;
182 #gpio-cells = <2>;
183 gpio-ranges = <&pm8916_mpps 0 0 4>;
184 interrupt-controller;
185 #interrupt-cells = <2>;
186 };
187
188 pm8916_gpios: gpio@c000 {
189 compatible = "qcom,pm8916-gpio", "qcom,spmi-gpio";
190 reg = <0xc000>;
191 gpio-controller;
192 gpio-ranges = <&pm8916_gpios 0 0 4>;
193 #gpio-cells = <2>;
194 interrupt-controller;
195 #interrupt-cells = <2>;
196 };
197 };
198
199 pm8916_1: pmic@1 {
200 compatible = "qcom,pm8916", "qcom,spmi-pmic";
201 reg = <0x1 SPMI_USID>;
202 #address-cells = <1>;
203 #size-cells = <0>;
204
205 pm8916_pwm: pwm {
206 compatible = "qcom,pm8916-pwm";
207
208 #pwm-cells = <2>;
209
210 status = "disabled";
211 };
212
213 pm8916_vib: vibrator@c000 {
214 compatible = "qcom,pm8916-vib";
215 reg = <0xc000>;
216 status = "disabled";
217 };
218
219 pm8916_codec: audio-codec@f000 {
220 compatible = "qcom,pm8916-wcd-analog-codec";
221 reg = <0xf000>;
222 interrupt-parent = <&spmi_bus>;
223 interrupts = <0x1 0xf0 0x0 IRQ_TYPE_NONE>,
224 <0x1 0xf0 0x1 IRQ_TYPE_NONE>,
225 <0x1 0xf0 0x2 IRQ_TYPE_NONE>,
226 <0x1 0xf0 0x3 IRQ_TYPE_NONE>,
227 <0x1 0xf0 0x4 IRQ_TYPE_NONE>,
228 <0x1 0xf0 0x5 IRQ_TYPE_NONE>,
229 <0x1 0xf0 0x6 IRQ_TYPE_NONE>,
230 <0x1 0xf0 0x7 IRQ_TYPE_NONE>,
231 <0x1 0xf1 0x0 IRQ_TYPE_NONE>,
232 <0x1 0xf1 0x1 IRQ_TYPE_NONE>,
233 <0x1 0xf1 0x2 IRQ_TYPE_NONE>,
234 <0x1 0xf1 0x3 IRQ_TYPE_NONE>,
235 <0x1 0xf1 0x4 IRQ_TYPE_NONE>,
236 <0x1 0xf1 0x5 IRQ_TYPE_NONE>;
237 interrupt-names = "cdc_spk_cnp_int",
238 "cdc_spk_clip_int",
239 "cdc_spk_ocp_int",
240 "mbhc_ins_rem_det1",
241 "mbhc_but_rel_det",
242 "mbhc_but_press_det",
243 "mbhc_ins_rem_det",
244 "mbhc_switch_int",
245 "cdc_ear_ocp_int",
246 "cdc_hphr_ocp_int",
247 "cdc_hphl_ocp_det",
248 "cdc_ear_cnp_int",
249 "cdc_hphr_cnp_int",
250 "cdc_hphl_cnp_int";
251 #sound-dai-cells = <1>;
252 status = "disabled";
253 };
254 };
255 };
Linux® is a registered trademark of Linus Torvalds in the United States and other countries.
TOMOYO® is a registered trademark of NTT DATA CORPORATION.