1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
2 /*
3 * Google Lazor board device tree source
4 *
5 * Copyright 2020 Google LLC.
6 */
7
8 #include "sc7180-trogdor-clamshell.dtsi"
9
10 &ap_sar_sensor {
11 semtech,cs0-ground;
12 semtech,combined-sensors = <3>;
13 semtech,resolution = "fine";
14 semtech,startup-sensor = <0>;
15 semtech,proxraw-strength = <8>;
16 semtech,avg-pos-strength = <64>;
17 };
18
19 &ap_tp_i2c {
20 status = "okay";
21 };
22
23 /*
24 * Lazor is stuffed with a 47k NTC as charger thermistor which currently is
25 * not supported by the PM6150 ADC driver. Disable the charger thermal zone
26 * to avoid using bogus temperature values.
27 */
28 &charger_thermal {
29 status = "disabled";
30 };
31
32 ap_ts_pen_1v8: &i2c4 {
33 status = "okay";
34 clock-frequency = <400000>;
35
36 ap_ts: touchscreen@10 {
37 compatible = "hid-over-i2c";
38 reg = <0x10>;
39 pinctrl-names = "default";
40 pinctrl-0 = <&ts_int_l>, <&ts_reset_l>;
41
42 interrupt-parent = <&tlmm>;
43 interrupts = <9 IRQ_TYPE_LEVEL_LOW>;
44
45 panel = <&panel>;
46 post-power-on-delay-ms = <20>;
47 hid-descr-addr = <0x0001>;
48
49 vdd-supply = <&pp3300_ts>;
50 };
51 };
52
53 &panel {
54 compatible = "boe,nv133fhm-n62";
55 };
56
57 &pm6150_adc {
58 /delete-node/ channel@4f;
59 };
60
61 &pm6150_adc_tm {
62 status = "disabled";
63
64 /delete-node/ charger-thermistor@0;
65 };
66
67 &trackpad {
68 interrupts = <58 IRQ_TYPE_EDGE_FALLING>;
69 };
70
71 &wifi {
72 qcom,ath10k-calibration-variant = "GO_LAZOR";
73 };
74
75 /* PINCTRL - modifications to sc7180-trogdor.dtsi */
76
77 &trackpad_int_1v8_odl {
78 pins = "gpio58";
79 };
80
81 &ts_reset_l {
82 /* This pin is not connected on -rev0, pull up to park. */
83 /delete-property/bias-disable;
84 bias-pull-up;
85 };
86
87 /* PINCTRL - board-specific pinctrl */
88
89 &tlmm {
90 gpio-line-names = "ESIM_MISO",
91 "ESIM_MOSI",
92 "ESIM_CLK",
93 "ESIM_CS_L",
94 "",
95 "",
96 "AP_TP_I2C_SDA",
97 "AP_TP_I2C_SCL",
98 "TS_RESET_L",
99 "TS_INT_L",
100 "",
101 "EDP_BRIJ_IRQ",
102 "AP_EDP_BKLTEN",
103 "AP_RAM_ID2",
104 "",
105 "EDP_BRIJ_I2C_SDA",
106 "EDP_BRIJ_I2C_SCL",
107 "HUB_RST_L",
108 "",
109 "AP_RAM_ID1",
110 "AP_SKU_ID2",
111 "",
112 "",
113 "AMP_EN",
114 "P_SENSOR_INT_L",
115 "AP_SAR_SENSOR_SDA",
116 "AP_SAR_SENSOR_SCL",
117 "",
118 "HP_IRQ",
119 "AP_RAM_ID0",
120 "EN_PP3300_DX_EDP",
121 "AP_BRD_ID2",
122 "BRIJ_SUSPEND",
123 "AP_BRD_ID0",
124 "AP_H1_SPI_MISO",
125 "AP_H1_SPI_MOSI",
126 "AP_H1_SPI_CLK",
127 "AP_H1_SPI_CS_L",
128 "",
129 "",
130 "",
131 "",
132 "H1_AP_INT_ODL",
133 "",
134 "UART_AP_TX_DBG_RX",
135 "UART_DBG_TX_AP_RX",
136 "HP_I2C_SDA",
137 "HP_I2C_SCL",
138 "FORCED_USB_BOOT",
139 "",
140 "",
141 "AMP_DIN",
142 "",
143 "HP_BCLK",
144 "HP_LRCLK",
145 "HP_DOUT",
146 "HP_DIN",
147 "HP_MCLK",
148 "TRACKPAD_INT_1V8_ODL",
149 "AP_EC_SPI_MISO",
150 "AP_EC_SPI_MOSI",
151 "AP_EC_SPI_CLK",
152 "AP_EC_SPI_CS_L",
153 "AP_SPI_CLK",
154 "AP_SPI_MOSI",
155 "AP_SPI_MISO",
156 /*
157 * AP_FLASH_WP_L is crossystem ABI. Schematics
158 * call it BIOS_FLASH_WP_L.
159 */
160 "AP_FLASH_WP_L",
161 "DBG_SPI_HOLD_L",
162 "AP_SPI_CS0_L",
163 "",
164 "",
165 "",
166 "",
167 "",
168 "",
169 "UIM2_DATA",
170 "UIM2_CLK",
171 "UIM2_RST",
172 "UIM2_PRESENT",
173 "UIM1_DATA",
174 "UIM1_CLK",
175 "UIM1_RST",
176 "",
177 "EN_PP3300_CODEC",
178 "EN_PP3300_HUB",
179 "",
180 "",
181 "",
182 "",
183 "",
184 "AP_SKU_ID1",
185 "AP_RST_REQ",
186 "",
187 "AP_BRD_ID1",
188 "AP_EC_INT_L",
189 "",
190 "",
191 "",
192 "",
193 "",
194 "",
195 "",
196 "",
197 "",
198 "EDP_BRIJ_EN",
199 "AP_SKU_ID0",
200 "",
201 "",
202 "",
203 "",
204 "",
205 "",
206 "",
207 "",
208 "",
209 "AP_TS_PEN_I2C_SDA",
210 "AP_TS_PEN_I2C_SCL",
211 "DP_HOT_PLUG_DET",
212 "EC_IN_RW_ODL";
213 };
Linux® is a registered trademark of Linus Torvalds in the United States and other countries.
TOMOYO® is a registered trademark of NTT DATA CORPORATION.